Psay a dvd encoded with dolby digital, Subwoofer, Remote control only – Panasonic SC-DK2 User Manual
Page 38: To stop the test noise, To select a specific speaker, Bcd h
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

- VOLUME +
( ) ( 1
b
CD
h
L
C h
.L * -J T<
r tOJ3
Enjoying surround sound
PSay a DVD encoded with Dolby Digital.
The nDDIGITAL indicator lights.
Subwoofer
You can enhance the surround sound by connecting another
subwoofer (“> page 52 for connection).
If you connect a subwoofer:
Press and hold [S.WOOFER] on the main unit until “SUB W ON" is
displayed.
If you disconnect the subwoofer;
Press and hold [S.WOOFER] on the main unit uniii “SUB W OFF" is
displayed.
O To down-mix Dolby Digital (5.1 ch) signals to 2
channels
Remote control only
Press [SHIFT] + [Mix 2CH],
To cancel, press [SHIFT) + [MIX 2CH].
Speaker level adjustments
If the level of the speakers appears to be different while listening to a
source, adjust the level of the speakers to the same apparent level.
Sit in the normal listening position and make the adjustments with
the remote control.
Remote control only
Preparation: Turn other surround systems off.
® Press [SHIFT] + [TEST] to output a test signal.
A test signal is output from the speakers in the following order.
Lch:
Front left speaker
Cch:
Center speaker
Rch:
Front right speaker
RSch: Right surround speaker
LSch: Left surround speaker
The speaker’s indicator flashes while the speaker is outputting
the test signal.
No signal is output for the subwoofer,
d) Press [VOLUME (- or +)] to set the volume level of the front
speakers normally used for enjoying the source.
® While the speaker to be adjusted is outputting a signal
Press the cursor buttons [A] (to increase level) or [V] (to
decrease level) to adjust the level of each speaker.
Lch, Rch: -16 dB to 0 dB
Cch, RSch, LSch: -10 dB to +6 dB
Repeat step CD to adjust the level accordingly.
To stop the test noise
Press [SHIFT] + [TEST] again.
To select a specific speaker
1. Press [SHIFT] + [CH SELECT] to select the speaker.
Each time you press the buttons:
Lch ^ Cch “* Rch RSch ^ LSch SWch
-_____________________________ 1
SWch: Subwoofer (Adjust only when connected)
2. While the speaker's indicator is flashing
Press the cursor buttons [A] or [T] to adjust the level.
1QT5327