Panasonic DVD-RV41 - Manual (Page 32)

Picture
Picture distorted during search. •The picture will be somewhat distorted at times; This i$ normal.
No picture. •Ensure that the equipment is connected properly. ©
• Make sure the television is on.
• Ensure the television’s video input setting (e.g., VIDEO 1) is correct.
The picture shown on the •Go to the Video menu in the SETUP screen, and change ‘TV Aspecf to suit your television.
television is not normal. You may also need to change the screen mode on the television itself. 0
(The sides of the picture are cut • Ensure that the unit is connected directly to the television, and is not connected through a video
off or black bands appear at the
top and bottom of the screen.)
cassette recorder.
Displays
“NO PLAY” appears on the unit’s
display.
•You inserted a disc the unit cannot play; insert one it can, 0
No on-screen display. • Go to the Display menu in the SETUP screen, and select “On" for “On-Screen Messages", ©
GUI screens not displayed or
only partially displayed on the
television.
• Press tA,T] while the rightmost icon is highlighted to move them down. ©
The disc’s menu is displayed in a
different language. • Go to the Disc menu in the SETUP screen, and select the preferred language for “Menus". ©
No menu play. •Menus are only displayed if they are recorded on the disc.
“CHECK THE DISC” appears on
the unit’s display.
•Disc is dirty. Wipe the disc clean. ©
“Hnn” appears on the unit’s •Trouble is likely to have occurred. The number following “H" depends on the status of the unit.
display. Reset procedure:
Press [cl)/t] to switch the unit to the standby mode and then back to ON.
□□ stands for a number. Alternatively, press to switch the unit to the standby mode, disconnect the AC mains lead,
and then reconnect it.
•If the service numbers fail to clear, note the service number and contact a qualified service
person.
“NO DISC” appears on the unit’s •You haven’t inserted a disc; insert one.
display. •You haven't inserted the disc correctly; insert it correctly.
Maintenance
To clean this unit, wipe with a soft, dry cloth.
If the surfaces are extremely dirty, use a soft cloth dampened with a soap and water solution or a weak detergent solution.
•Never use alcohol, paint thinner or benzine to clean this unit.
•Before using chemically treated cloth, read the instructions that came with the cloth carefully.