Panasonic OMNIVISION PV-M2066 - Manual (Page 24)

VCR Plus+ Set Up
This setup is for VCR Plus+ and
timer programming only.
In order for your Combination VCR to do a VCR Plus+ recording (see top of page 25 for expianation of VCR Plus+), or a timer
recording of cable stations, some setup is required. First, find the antenna or cable connection that matches yours. Then, follow
the instructions below for your connection.
Choose your Connection Type
(Then, follow the instructions under the diagram.)
[ Connection Type A ]
Back o1
Combination VCR
Cable Box
RF Coaxial Cabla
(supplied)
Cable/
Antenna
Front of
Combination VCR
\
VIDEO №1 L'AUDIO IN-R
0 0
If your system looks like this diagram,
do the following.
1. Complete the “Cable Box Set Up”
section at right.
2. Skip page 25 and go directly to page
26 for VCR Plus+ Programming.
Connection Type B
Back of
Combination VCR
From Antenna
Of Cable
Cable/
Antenna
RF Coaxial Cabla
(supplied)
If your system looks like one of these,
do the following.
1. Skip the “Cable Box Set Up” section
at right and turn to page 25.
2. Complete the “VCR Plus+ Channel Set
Up” section on page 25.
3. Turn to page 26 for VCR Plus+
Prog ramming.
Cable Box Set Up
For connection A (see left) only
Push MENU to
display the menu.
MENU
Rotate and push
the WHEEL
to select “CH.”
MAIN MENU
IDIOMA
ROTATE WHEEL
PUSH WHEEL
Rotate and push
the WHEEL
to select CABLE
BOX SET UP. VCR Plus+ CH SET UP
SELECT
SET
END
Select YES if all channels
are received via the cable
box (connection “A” at left).
Then, go to step 5.
Select NO if your cable
connection resembles
connection “B” at left.
Push MENU to exit and turn to page 25.
Rotate the WHEEL
to change the
output channel
number.
• Number shown is
example only. Be sure
to enter your cable box
output channel.
If necessary, refer to your cable box manual.
If you are using AudioA/ideo jack connection for your cable
box, select and set “VIDEO OUT" as the output channel.
MENU
Push MENU to
confirm your entry.
• This display appears for
five seconds. (Channel
shown is example only)
YOUR TV IS RECEIVING
THE OUTPUT OF CABLE BOX
CH 01
------- SET UP CHANNEL------------------
ANTENNA SYSTEM : CATV
AUTO SET
CABLE BOX SETUP
ROTATE WHEEL
PUSH Vi/HEEL
PUSH MENU KEY
ARE YOU USING
A CABLE BOX?
YES
IT m
SELECT ROTATE WHEEL
SET PUSH WHEEL
END PUSH MENU KEY
r
ENTER CABLE BOX OUTPUT
CHANNEL
EH
SELECT : ROTATE WHEEL
SET : PUSH WHEEL
END : PUSH MENU KEY
\___________ -)
f VCR Plus+ and PlusCode are trademarks of
Gemstar Development Corporation.
The VCR Plus+ system is manufactured under
license from Gemstar Development Corporation.
MENU
Push MENU twice
to return to the
normal screen.
Then, go directly to VCR Plus-i- Programming on page 26.
24