Yamaha HTR-5835 - Manual (Page 73)

TROUBLESHOO TING
Problem Cause Remedy
Refer to
page
Dolby Digital or DTS
sources cannot be
played. (Dolby Digital
or DTS indicator in
the front panel
display does not light
up.)
The connected component is not set to
output Dolby Digital or DTS digital
signals. Make an appropriate setting following the operating
instmctions for yom' component. —
The input mode is set to ANALOG. Set the input mode to AUTO or DTS. 30
A “humming” sound
can be heard.
Incorrect cable connections. Firmly connect the audio plugs. If the problem
persists, the cables may be defective. —
The volume level
cannot be Increased,
or the sound is
distorted.
The component connected to the OUT
(REC) jacks of this unit is turned off. Turn on the power to the component.
The sound effect
cannot be recorded.
It is not possible to record the sound effect
with a recording component.
'■——__________________
A source cannot be
recorded by a digital
recording component
connected to this
DIGITAL OUTPUT
Jack,
The source component is not connected to
this unit’s DIGITAL INPUT jacks. Connect the source component to the DIGITAL
INPUT jacks. 14-18, 47
Some components cannot record the
Dolby Digital or DTS sources.
'--------
A source cannot be
recorded by an
analog component
connected to the
AUDIO OUT jacks.
The source component is not connected to
this unit’s analog x\UDIO IN jacks. Connect the source component to the analog AUDIO
IN jacks. 14-18, 47
The sound field
parameters and some
other settings on this
unit cannot be
changed.
“MEMORY GUARD” in SET MENU is
set to ON. Select OFF. .78
This unit does not
operate properly.
The intema.1 microcomputer has been
frozen by an external elechic shock {such
as lightning or excessive static elechicity)
or by a power supply with low voltage. Disconnect the AC power cord from the outlet and
then plug it in again after about 30 seconds.
“CHECK SP WIRES”
appears in the front
panel display.
Speaker cables are short circuited. Make sure all speaker cables are connected correctly. 12
There is noise
interference from
digital or radio
frequency equipment,
or this unit.
This unit is too close to the digital or high-
frequency equipment. Move this unit further away from such equipment.
The picture is
disturbed.
The video source uses scrambled or
encoded signals to prevent dubbing.
' -------------------------------- ________________
This unit suddenly
turns into the standby
mode.
The internal temperatui'e becomes too
high and the overheat protection circuitry
lias been activated. Wait about 1 hour for tliis unit to cool down and then
turn it back on. —
69