Select a sound field program if desired, To listen with headphones (“silent cinema”), To adjust the tone – Yamaha HTR-5835 User Manual

Page 29: To mute the sound

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

PLAYBACK

Select a sound field program if desired.

Press PROGRAM

repeatedly (or press AMP

to select the AMP mode, then press one of the sound
field program buttons on the remote control) to select
a sound field program. (See page 48 for details about
sound field programs.)

PROGRASVt l:.~

Front panel

Remote control

■ To listen with headphones

(“SILENT CINEMA”)

“SILENT CINEMA” allows you to enjoy multi-channel

music or movie sound, including Dolby Digital and DTS

surround, through ordinaiy headphones. “SIEENT
CINEMA” activates automatically whenever you connect

headphones to the PHONES jack while listening to

CINEMA DSP or HiFi DSP sound field programs. When
activated, the “SILENT CINEMA” indicator lights up in
the front panel display

Notes

• This unit will not be set to “SILENT CINEMA” when MULTI

CH INPUT is selected as the input source.

• “SILENT CINEMA” is not effective when the Direct Stereo or

2ch Stereo program is selected, or in STRAIGHT mode.

TONE CONTROL

♦

BASSiTREELE +

■ To adjust the tone

You can adjust the tonal quality

of your front left and right
speakers or headphones (when
connected).
Press TONE CONTROL on the
front panel repeatedly to select

TREBLE or BASS, then press
BASS/TREBLE

-/+

repeatedly

to increase or decrease.

• Select TREBLE to adjust the

high frequency response.

• Select BASS to adjust the low frequency response.

-spc.ifcr and headphone adjustments are stored independently.

Notes

• If> or increase or decrease the high-frequency or low-frequency

sound to an extreme level, the tonal quality of the surround
speakers may not match that of the front left and right speakers.

• TONE CONTROL is not effective with the Direct Stereo

program (page 29) or MULTI CH INPUT.

• When TC- BYPASS is set to AUTO (page 57), and BASS and

TREBLE are set to 0 dB, audio output automatically bypasses
this unit’s tone control circuitry.

■ To mute the sound

Press MLITE on the remote control.
The MUTE indicator flashes m the
front panel display.
To resume the audio output, press

MUTE again (or press VOLUME -,'+).

The MUTE indicator disappears from

the display.

You can adjust the muting level (see page 57).