Panasonic NE-1757 - Manual (Page 13)

J. To Select Beep Tone Options
The Beep Tone can be set for Loudness—(4 Levels) and Length of Tone—{2 Options). You can select
the combination of Loudness and Length that best suits your needs.
The Beep Tone is set at the factory for the loudest level (#3) and for 3 Beeps.
/------------------------- >
_______________________ ______________ é
f ------------------------
_______________________
n
u
______________ >
-PROS- / /“
' 3 u c
__________________
r n
L r
STAGE Ml wed def
PROG / /- /-/
3 O C L r
1 ______________
STAGE « MED def
-?R0fi- j f ~
' 3 o c
^ 2
-------------- '
/ n
L I
- J
STAGE HI MEI ) DEF
PROG / /~ / n
3 U L L 1
<_____ è ----------------- J
STAGE « MED DEF
To Select Loudness Level
1. Make sure the unit is plugged into a properly grounded electrical outlet.
2. Open the door and leave it open. The cavity light will come on. The cooling fan will
start if the oven has been operating. “0” will appear in the display.
3. Touch PROG pad first and then within 1 minute press “0” pad. “3 bEEP” and first stage
heating indicator “1” will appear in the display window and "PROG” will blink.
4. Select the desired sound loudness level by touching “0" pad.
Repeated touching of ‘ ‘0” pad will lower the loudness of the tone all the way to silent.
The Tone will sound at its loudness level and the display window will display loudness
level in digits (3 to 0—loud to silent) followed by the word “bEEP”.
[Example]: 3 bEEP—Loud
2 bEEP—Medium
1 bEEP—Soft
0 bEEP—Silent
5. Touch the PROG pad again, “PROG” will stop blinking. You have completed
selecting the loudness level.
6. Close the door. One minute later display window will go blank and the cooling fan will
stop.
To Select Length of Tone
At end of heating cycle there are 2 options.
A. 3 Beeps (Factory Setting)
B. 60 seconds of Short Beeps
To Program for 60 Seconds of Short Beeps
1. Complete steps 1 -4 above (Select loudness level).
*DO NOT CLOSE THE DOOR*
2. Touch Program Pad and quickly select the desired tone length by touching “0” pad.
A. “PROG" will blink.
B. Current loudness level will be displayed.
C. Second Stage Heating indicator will illuminate.
[Example]: First Stage Indicator “1" llluminated=3 BEEPS
Second Stage Indicator “2” Illuminated=60 Seconds of BEEPS
3. When the desired length of tone has been selected (1, or 2), press the PROG pad
again.
A. “PROG" will illuminate.
B. 3 seconds later, the display window will show “0”.
4. Close the Door. One minute later display window will go blank and the cooling fan will
stop.
-
13
-