Infra-red remote controller and digital scanner, How to operate the digital scanner, Ocp [=□ ooa a ' ..... -........ ---------- --- r – Panasonic NVG40 User Manual
Page 6
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
INFRA-RED REMOTE CONTROLLER AND DIGITAL SCANNER
Part Number: VEQ0684
&
o
cp
[=□
ooa
a
' ..... -........
---------- --- r
■o
■0
CZ] CB CZl
-©
0 VTR On/Off Button
0 Clock/Counter Selector
o
Record Buttons {•)
O Pause/Still Button (II)
0 Rewind ◄◄/Review Q Button
© Play Button (P-)
0 Slow Buttons
© Fast Forward P'P’/Cue @ Button
© Still Advance Button (ll^)
0 Stop Button (■)
0 Programme Position (Channel) Selector Buttons
0
VTR/TV Selector
(T) Transmit Button
Bar Code Reading Section
@ Digital Scanner On/Off Switch
@ Transmitting Section
How to Operate the Digital Scanner
Set the Digital Scanner On/Off Switch to ''ON".
•If no operation is performed for more than 25 seconds, the
scanner will automatically switch over to the power-saving
standby condition and the lamp wilt go off. (In this case, if
bar codes have already been read but not yet transmitted
to the VTR, the data will be cancelled.)
•When the Digital Scanner On/Off Switch is set to “ON"
but the lamp is not lit, set the switch to “OFF" and then to
“ON” again.
Tracing the Gar Codes
(§) Place the Digital Scanner vertically on the Small Box.
(§) Trace the bar code quickly in the direction of the arrow.
-
6
-
O