Panasonic NVG40 - Manual (Page 12)

PLAYBACK
p Memory/Search Lock Button
Repeatedly pressing this button will change the indication in
the following order: "M" (Memory) -> “S" (Search Lock)
both indications are off ^ “M”...
REW/a—PLAY—a/FF
CLOCK/
COUNTER
CP
MEMORY/
SEARCH LOCK RESET
C±3 C3- Reset Button
Preparation
•Make sure that the Timer Record Function is set to “Off".
•Insert a recorded video cassette.
When a video cassette is already inside the VTR, press
- the VTR OrVOff Switch to turn it on.
•Turn the TV set on and select the video playback channel.
Rewind and Fast Forward
Press the Rewind ■^◄/Review (3 Button to rewind the
tape.
Press the Fast Forward ►►/Cue © Button to wind the
tape fonward rapidly.
Lap Time Counter
It shows the elapsed recording or playback time.
_ n n n n n
u ^ u u , u u
Hours
j
Seconds
Minutes
The indication will appear when the tape is
rewound further than the tape counter position
“ 0 : 00 . 00 ”.
-Clock/Counter Selector
By pressing this button when the VTR On/Off Switch is set
to “On’’, it is possible to change over the display mode of
the Clock/Counter Display in the Multi-Function Display
from “Clock” to “Counter" Display and vice versa.
•Even if the selector button is set for “Counter" the display
will automatically changes over to “Clock" Display in all
the following cases: When you set the VTR On/Off Switch
to “Off", adjust the clock to the present time, programme
a timer recording, check a timer recording programme or
programme and perform an OTR.
•When the Clock/Counter Display shows the time, the
counter cannot be reset and the Memory and Search Lock
Function cannot be activated (“M" and “S” indication
does not light up).
Memory Functiorr
The Memory function makes it simple and fast to find a
certain position on the tape later again, simply by pressing
the Reset Button at that position to set the tape counter to
“0;00.00” and by pressing the Memory/Search Lock
Button. During Rewind or Fast Forward, the tape will then
stop at approximately the desired position.
Memory Indication
COUNT
M
Search Lock Indication
n • n n n 1 1 U ' U
u.
u u
•Even if the Clock/Counter Display is switched over
to “Clock" Display after pressing the Memory/
Search Lock Button, the Memory function will stop
the tape at the desired position.
Mf the figures on the Tape Counter do not change
during Fast Forward, Rewind or any of the Playback
functions, this means that nothing is recorded on
that tape section.
►The Tape Counter is automatically reset to
“0:00.00" when the video cassette is ejected.
-
12
“