Panasonic NVG40 - Manual (Page 23)

DUBBING (COPYING)
Dubbing (copying) from one video cassette to another.
AUDIO IN VIDEO IN
VTR for Recording
Preparation
• Press the VTR On/Off Switches to turn both VTRs on.
•Make the necessary connections as shown in the connec­
tion diagram.
O Place the recorded cassette in the playback VTR and a
blank video cassette with the erasure prevention tab
intact in the recording VTR.
Q Press the Record Button (•) on the recording VTR.
O Press the Play Button (►) on the playback VTR.
O Press the Stop Button (■} on both VTRs to stop the
dubbing.
•To assure smooth, noiseless cuts when interrupting
the recording, always use the Pause/Stiil Button
(II).
•To obtain smooth cuts when starting the recording
from the stop mode:
1. Play back the last part of the previously recorded
material to confirm its ending point, and then
press the Pause/Still Button
(II).
2. Press the Record Button (•).
(The VTR is still in the pause mode.)
3. To start recording, press the Pause/Still Button
(II) again.
•The picture quality of a re-recorded tape is not as
good as that of the original.
•Disconnect alt cables from the Video Input and
Audio Input sockets after finishing the recording. If
they remain connectd, it is impossible to record TV
programmes.
-
23
-