Panasonic NVG40 - Manual (Page 22)

CAMERA RECORDING
0 Turn the Camera AC Adaptor on and make the
necessary adjustments on the camera.
Refer to the operating instructions of the camera you
are using.
@ Press the Record Button (•) on the VTR to start
recording.
Avoid recording unwanted material;
Press the Pause/Slill Button (II) of the VTR, and the
recording will stop temporarily. To restart recording, press
the Pause/Still Button (II), again.
© Press the Stop Button (■) on the VTR to stop the
recording,
•if you leave the VTR in the pause mode for more
than 5 minutes, the VTR will stop automatically to
protect the tape and the video heads.
• Even if the video camera is equipped with video
recorder remote control functions, this VTR can not
be remote-controlled from the camera.
•Disconnect all cables from the Video Input and
Audio Input Sockets after finishing camera record­
ing.
If they remain connected, it is impossible to record
TV programmes.
Preparation
•Connect the Video Camera via the Camera AC Adaptor to
the VTR as shown in the illustration above.
•Insert a video cassette with the erasure prevention tab
intact.
When a video cassette is already inside the VTR, press
the VTR On/Off Switch to turn it on.
•Set the VTR/TV Selector to "VTR".
-22-