Panasonic KX-TG2670N - Manual (Page 82)

Before Requesting Help
Cordless Telephone
Problem Remedy
“No link to base.
Place on cradle and
try again.” is displayed
and an alarm tone sounds.
•You are too far from the base unit. Move
closer and try again.
•Insert the handset in the cradle and try
again.
•Plug in the AC adaptor.
•Extend the handset antenna fully.
•Raise the base unit antennas.
Static, sound cuts in/out,
fades. Interference from
other electrical units.
•Locate the handset and the base unit
away from other electrical appliances
(P- 3).
•Move closer to the base unit.
•Extend the handset antenna fully.
•Raise the base unit antennas.
•Press
iFUNCTION/CHl to select a clearer
channel.
The handset and/or the base
unit do not ring.
•The ringer volume is set to OFF. Set to
HIGH or LOW {p. 17).
The handset display is
blank.
•The handset is in the standby mode
(p. 9). Press ®, ®, 0 or ® to turn
the display on.
The handset display is still
blank after pressing ®. ®.
@ or ®.
•Charge the battery fully (p. 11).
You cannot store a name
and phone number in the
directory.
•You cannot store an item in the directory
while the unit is in the talk,
speakerphone or intercom mode, or
while the answering system is in use.
•Do not pause for over 60 seconds while
storing.
While programming or
searching, the unit starts to
ring and stops the program/
search.
•To answer the call, press [*%1. 1 1 or
[DIGITAL SP-PHONEi. Start again from
the beginning after hanging up.
82