Panasonic KX-TG2670N - Manual (Page 58)

Pager Call
This feature allows you to alert your pager when the unit records an
incoming message or receives a Caller ID call (p. 32). You can retrieve
the message from a touch tone telephone (p. 64). If you subscribe to a
Caller ID service, the caller’s telephone number will be displayed on your
pager. First program the following settings (p. 58-62), then set the unit to
call the pager. Use the handset near the base unit.
Make sure that the unit is in the standby mode initially.
Storing a Pager Number
if you use a 1-800 pager number, see the next page for the storing
procedure.
Press I FUNCTION/^. 1
Press ® or @ repeatedly until the arrow
points to “Program”.
Press B (Yes key).
Press ® or B repeatedly until the arrow
points to “TAD program”.
Press B (Yes key).
•The base unit display shows programming
options.
►Program
Calling pager
T A ►=Yes
►Save DIRECT#
Set flash time
| T A ►=Yes
Set dial mode
►TAD program
T A ►=Yes
Answering
system setting.
See base unit.
Press [¥).
Base unit display
Enter your pager number, and press iREDIAUPAUSEl twice.* Enter
the access code, if required by your pager company, and press
IREDIAL/PAUSEI twice again.*
•The entered number is displayed on the base unit.
•If you misdial, press ICLEARl and enter the correct number.
•You can enter a total of 44 digits.
58