Panasonic NV-G21 - Manual (Page 25)

CAMERA RECORDING
Remote Control Plug:
No Connection
Preparation
•Connect the video camera via the Camera AC Adaptor to
the VTR as shown in the illustration above.
•Insert a video cassette with erasure prevention tab intact.
When a video cassette is already inside the VTR, press
the VTR On/Off Switch to turn it on.
•Make sure that the Timer Record Button is set to “Off”.
•Set the VTRrrv Selector to “VTR”.
^ Turn the Camera AC Adaptor on and make the
necessary adjustments on the camera.
Refer to the operating instructions of the camera you
are using.
@ Press the Record Button {•) on the VTR to start
recording.
REC<
REC
Avoid recording unwanted material:
Press the Pause/Still Button (II) of the VTR, and the
recording will stop temporarily. To restart recording, press
the Pause/Still Button ( I I ) , again.
CAMERA
(Optional)
CAMERA AC
Adaptor
(Optional)
AUDIO IN VIDEO IN
0
Press the Stop Button (■) on the VTR to stop
recording.
STOP
□
Ш- \
•If you leave the VTR in the pause mode for more
than 5 minutes, the VTR will stop automatically to
protect the tape and the video heads.
•Even if the video camera is equipped with video
recorder remote control functions, this VTR can not
be remotely-controlled from the camera.
•Disconnect all cables from the Video Input and
Audio Input sockets after finishing camera record­
ing.
If they remain connected, it is impossible to record
TV programmes.