Panasonic KX-FP200 - Manual (Page 27)

Automatm dsalmg
Stoiriog pDi©Bi© oymbers foir aytomsiti© dialing
The unit’s memory allows you to use both one-touch dialing and speed dialing for rapid access to your most
frequently dialed numbers.
One-touch dialing: 18 stations {Each of the 9 direct station keys is divided into an upper station and a lower
station).
oThe direct call station 1 key can be used as direct call station 1 (DIAL MODE) or as a
broad cast key (PROG. MODE). Both functions cannot be used at the same time.
Speed dialing: 100 additional dialing stations (60 stations if your unit is a KX-FP195). These stations are
assigned to 2-digit numbers (00-99 for KX-FP200, 00-59 for KX-FP195).
i Press [MENU] until the following message is
displayed.
Direct call
STORE TEL NO.
4l
Display:
One-touch dialing:
For upper stations (1-9)
Press one of the direct call station keys.
o|f you select direct call station 1, select
“DIAL MODE" by pressing (§), then press
[ START/C(^PY/SET ] to go to the next prompt.
For lower stations (10-18)
Press [LOWER), then press one of the direct
call station keys.
speed dialing:
Press then press the desired 2-digit number
(00-99 for KX-FP200 and 00-59 for KX-
FP195).
Enter the phone number up to 30 digits in length.
oTo enter a hyphen in a phone number, press
(HYPHEN) (direct call station 8).
Press [START/COPY/SET).
NAME=
7
Enter the station name, up to 10 characters, by
following the instructions on page 13.
Press (START/COPY/SET).
oTo program other stations, repeat steps 2 to 6.
Press (STOP).
Helpful hint:
oTo confirm stored phone numbers and station names,
print a telephone number list (see page 56).
To keep the phone number
secret
Press (SECRET] (direct call station 3) after
entering the phone number.
oThe phone number will not appear on the
display and the telephone number list.
o[SECRET] is not counted as a digit.
To erase a stored number and
station name
Press (STOP) in step 3 to erase the phone
number. Press [DELETE) (direct call station 7)
repeatedly in step 5 until all of the characters
are erased.
Then, press (START/COPY/SET).
27