Panasonic DVD-RV40 - Manual (Page 36)

Home theater
Note when connecting the optica) digital audio cable
Dust protection
cap
Align the plug with
the terminai
• Remove the dust protection cap from the optical digital audio out­
put terminai and connect the cable firmly so that the configurations
of both the cabie and the terminai match,
•Keep the dust protection cap and reattach when not using the
- terminai.
Optical digital audio cable
• Do not bend the optica! digital audio cabie when connecting it.
Coaxial audio cable DVD^RV40
System component or amplifier with digital audio input
terminals and speakers
• Read the instructions for the ampiifier and speakers or system
component for connection detaiis.
When you have finished connection
• Make changes to “7 Digital Audio Output" as shown (■* page 37).
PCM Down Conversion Yes^^
Dolby Digital PCM
DTS Digital Surround Off
MPEG PCM
iKif this is set to “No”, no audio will be output when DVDs recorded in 96 kHz linear PCM are played, (Audio will be output as it is if the DVD does
not have copyright protection recorded on it.)
•These changes to digital audio output must be made, otherwise signals the equipment cannot handle, bitstream, will be output.
If the signals are output as bitstream, "noise” will be output which can cause harm to your ears and speakers.
DVD-RV40 >ln “8 Speaker Settings", select “2 2-channel" (■» page 39).
The sound for speakers other than the front left and right speakers will not be heard if you do not select "2 2-channei".
•Additional equipment and cables are not supplied.
VQT8633