Magliner COOLIFT - Manual (Page 14)

1-800-MAGLINE (624-5463) Page 14 www.magliner.com
CooLift
®
Using the AC Charging Unit
1) Connect the AC charger plug to an AC outlet (120v domestic or 230v international).
2) Plug the output cord from the charging unit into the charging port located on the top of the
battery box.
3) Turn the power switch on the charging unit to the “On” position.
4) When disconnecting the charging unit from the CooLift or a supplementary battery box:
a) Turn the charging unit power switch to “Off” position;
b) Unplug the charging unit from the power source (AC outlet);
c) Disconnect the charging unit from the charging port.
A completely drained battery needs 2 hours to fully charge. The LED will illuminate to
indicate one of the following conditions:
Solid Yellow – Battery is charging
Solid Green – Battery has fully charged and is ready for use
Flashing Green – The output is not connected; check all
connectors and fuses
NOTE: Your AC charger model may have two LED lights. If your charger has two LEDs, a solid red
light on the charging unit is an indication the power is on and should remain on the entire time it is
plugged into the power source and the battery.
NOTE: There are two operational fuses on the charging unit located at each end. A spare fuse is
located adjacent to the main power connection.
Note: Battery may be charged as often as desired. Magline recommends charging at least
once after each delivery route is complete.