Magliner QUICK PICK ADAPTER FOR INDUSTRIAL BDT - Manual

A
B
D
A
B D
A
CENTER CASTER
MOUNTING PLATE
C
A
C
A
A
IF REQUIRED
DRILL O .328
(2) PLCS.
.750
1.000
(total truck width)
POSITION #306081 STOP
AND USE AS DRILL GUIDE
RDT Quick Pick Adapter
Assembly Instructions
B8153 Revised 3/13 © Copyright 2010-2013, Magline, Inc.
Kit 306082 consists of items below: 1
A Hex lock nut - 5/16-18 4 80676
B Hex head bolt - 5/16"-18 X 1” long 4 80011
C Quick Pick Adapter 2 306081
D Flat washer - 5/16” 4 80701
ITEM DESCRIPTION QTY. PART NO.
PARTS LIST
TOOLS REQUIRED
• (1) STANDARD 1/2" WRENCH
• (1) STANDARD SOCKET
WRENCH
• (1) STANDARD 1/2" SOCKET
FIGURE 1
QUICK PICK ADAPTER
ASSEMBLY
Position the Quick Pick Adapter (C) over the
holes as shown in Figure 1. Fasten the 5/16” x 1” hex head bolts (B),
using a washer (D) between the bolt and the Quick Pick Adapter, with the 5/16” hex lock nuts (A).
NOTE: Tighten all bolts securely. (Recommended: 5/16” bolts should be tightened to a torque value of 10-11 ft.-lbs.)
A
A
IF REQUIRED
DRILL O .328
(2) PLCS.
.750
1.000
(total truck width)
POSITION #306081 STOP
AND USE AS DRILL GUIDE
FIELD RETRO-FIT
Field Deck Weldment Retro-Fit for units built prior to 12/2004
1. Layout the holes as shown in SECTION A-A of Figure 2, it is recommended to center punch before drilling holes.
Quick Pick Adapter can be used as template.
TOOLS REQUIRED
• (1) .328 DRILL (21/64)
• (1) POWERED DRILL
• (1) TAPE MEASURE OR RULER
• (2) CLAMPS
FIGURE 2
Please consult Magline to verify compatibility with forks
CROSS SECTION OF RDT
www.magliner.com
Magline, Inc., 1205 West Cedar Street, Standish, MI 48658 • (800) 624-5463 • (989) 512-1000