Warranty information, Adjusting the cable tension – Magliner BRAKE TRUCK Y-Cable User Manual

Page 8

1. While the yoke is unattached from the brake handle actuator, pull up on the cable until the paddles make contact with

the wheels.

2. Turn the yoke on the top of the cable clockwise (moving down the cable’s threaded stud) until the holes in the yoke

are aligned with the holes in the brake handle actuator tab while pulling up on the cable (see page 7, Figure 9). Then

loosen the yoke by turning it counter-clockwise several turns.

3. Attach the cable to the brake handle actuator tab with a

”-20 x 1” long pan head machine screw (C) and

”-20

locknut (D) and test to be sure there is no drag of the paddles on the wheels. If so, loosen the yoke another one or

two turns and re-test. (Note: This typically requires the yoke to be loosened a total of 4 to 8 revolutions.)

4. When adjusted, tighten the screw and lock nut that secure the yoke to the actuator with the #2 Phillips head

screwdriver and the 7/16” wrench.

5. Tighten the jam nut against the bottom of the yoke using the 7/16” wrench. Be sure the yoke can move freely on the

actuator.

ADJUSTING THE CABLE TENSION

WARRANTY INFORMATION

Magline One-Year Limited Warranty
Magliner products have a one (1) year warranty from the date of purchase against defects in workmanship or

material.
Any part or component, except items covered by warranties of other manufacturers, returned to the factory or

service center freight prepaid by the owner, found upon examination by Magline, Inc. to be defective or the result of

improper workmanship by the factory will be repaired or replaced without charge and returned to the owner freight

prepaid by Magline, Inc.
Alterations of Magliner products void any warranty or liability on the part of Magline, Inc. Magline does not

guarantee product capacity if alterations are made.
To submit warranty information, please visit our online warranty form in the “tools & resources” section of www.

magliner.com