Magliner BRAKE TRUCK Y-Cable User Manual
Page 6
SINGLE PIN HANDLE PADDLE BRAKE ACTUATOR ASSEMBLY
(NO. 13A-C, 15A-C AND 17 HANDLES)
Parts A-D provided in single pin handle brake conversion kits 304162 and 304163.
1. Remove all four existing pan head machine screws and locknuts on each side of the hand truck handle
using the #2 Phillips head screwdriver and the 7/16” wrench.
2. Pull out the old handle and replace with the new handle with the welded slotted stub. Secure the new
handle with the previously removed handle mount screws and locknuts. Firmly tighten the screws with the
#2 Phillips head screwdriver and the 7/16” wrench.
3. Insert the steel bushing (A) in the largest endmost hole in the brake lever assembly (B) and position the
assembly in the slot of the handle stub. While holding the brake lever in place slide the ¼”-20 x 1¼” long
pan head machine screw (C) through the hole and secure with the ¼”-20 locknut (D) using the #2 Phillips
head screwdriver and the 7/16” wrench.
Note: If your hand truck model uses any of the handles listed above, you must purchase a brake handle ver-
sion of that handle if the handle does not have the welded slotted stub (see part labeled STUB below).
Item
Description
Qty.
Part No.
A
1/4” ID x 5/16” long spacer
1
304058
B
Brake lever assembly
1
304065
C
¼”-20 x 1-1/4” long pan head machine screw
1
80104
D
Hex locknut 1/4”-20
1
80675
STUB
A
B
C
D
Handle Description (handle sold separately)
Part No.
Handle No. 13A straight loop with cross brace and single pin with brake - 52”
300986
Handle No. 13B straight loop with cross brace and single pin with brake - 55”
301003
Handle No. 13C straight loop with cross brace and single pin with brake - 60”
300987
Handle No. 15A vertical loop with brake for straight braced frames - 52”
300988
Handle No. 15C vertical loop with brake for straight braced frames - 52”
300979
Handle No. 17 straight loop handle with pistol grip for brake
301169
6
Figure 5