Magliner BRAKE TRUCK Y-Cable - Manual (Page 5)

Parts A-G provided in loop handle brake conversion kit 304160.
1. Remove the lower existing pan head machine screw and locknut on each side of the hand truck handle
using the #2 Phillips head screwdriver and the 7/16” wrench.
2. Position the LH handle mounting bracket (C) as illustrated with the tab (TAB) facing away from center
of the truck and secure it with a ¼” x 2¼” long pan head machine screw (A) and locknut 1/4”-20 (B) as
illustrated in Figure 5.
3. Slide the loop handle actuator (E) through the hole in the mounted LH handle mounting bracket and the
RH handle mounting bracket (D). With the actuator handle resting on the tabs of the mounting brackets,
assemble the RH mount to the side rail using a ¼” x 2¼” long pan head machine screw (A) and locknut
1/4”-20 (B) as shown. Securely tighten the mounting screws using the #2 Phillips head screwdriver and
the 7/16” wrench.
4. Slide a 3/8” washer (F) on each end of the loop handle actuator and install a cotter pin (G) in the holes
provided. Using the needle nose pliers bend the end of the cotter pins to keep secure.
Item Description Qty. Part No.
A Pan head machine screw 1/4”-20 x 2-1/4” long 2 80263
B Hex locknut 1/4”-20 2 80675
C Handle mounting bracket LH 1 304153
D Handle mounting bracket RH 1 304154
E Loop handle actuator 1 304150
F Flat washer for 3/8” bolt 2 80702
G Cotter pin 3/32” x 3/4” 2 81075
LOOP TYPE HANDLE PADDLE BRAKE ASSEMBLY (NO. 11, 12, 19, 22 HANDLES)
5
Figure 5
A
A
B
C
D
E
F
G TAB
G