Dynon Avionics DX15 - Manual (Page 35)

DX15 User Guide 5‐3
Option: Backlight Behavior
Sets the behavior of the backlight when keys are pressed.
To set:
 Turn power OFF.
 Push and hold the LIGHT button.
 Turn power ON.
 If message "L‐On" is displayed, pushing LIGHT button causes
backlighting to be on continuously until LIGHT button is pushed again.
 If message "L‐5SEc" is displayed, pushing the LIGHT button still causes
backlighting to be on continuously until LIGHT button is pushed again.
However, pushing any other button (except Push‐to‐Talk) will also
cause backlighting to come on temporarily for five (5) seconds.
 The message will clear after two seconds, followed by a beep. You can
then use your DX15 normally.
 To change between modes, repeat the procedure (repeated cycles
toggle between the two modes).
Option: Memory Bank Scanning
Toggles whether or Memory Channels are scanned as a single block of
100 Memory Channels, or in banks of 10 Memory Channels each. See the
Memory Bank Scanning section for more details.
To set:
 Turn power OFF.
 Push and hold the MEM button.
 Turn power ON.
 If message "BANK‐n" is displayed, this behavior is OFF. Memory
Channels are scanned as a single large bank.