Dynon Avionics DX15 - Manual (Page 29)

DX15 User Guide 4‐5
Push the CLR button to stop Memory Channel band scanning mode at any
time.
Note: Only Memory Channels that have a frequency stored in them will
be scanned.
During Memory Channel scanning (or any of the other scan operations),
the decimal point between the digits flashes at a 1/2 second interval to
indicate that a scanning mode is active.
When a signal is received that exceeds the Squelch setting, Memory
Channel Scanning will pause for as long as the signal is being received.
Scanning will resume a few seconds after the last signal is received. To
force the radio to continue scanning while Memory Channel Scanning has
paused on a frequency, press either the ◄ or ► button to "nudge"
Memory Channel Scanning to continue its scan.
Memory Channel Scanning will continue until stopped by:
 Pushing the CLR button.
 Pushing PTT during the reception of a signal.
 Pushing the Emergency button.
SKIPPING MEMORY CHANNELS WHILE SCANNING
Some frequencies ‐ such as ATIS and AWOS ‐ are broadcast continuously.
While you may want to store these frequencies into Memory Channels
for quick access to them, you may not want to stop on them during a
scan of your Memory Channels. To skip a Memory Channel while
scanning:
 Select a Memory Channel as described in the Recalling Memory
Channels section above.
 Push and hold MEM for one to two (1‐2) seconds.
 The key icon will flash continuously to indicate that this Memory
Channel will be skipped during a scan.