Dynon Avionics DX15 - Manual (Page 30)

Features In Depth
4‐6 DX15 User Guide
 Repeat the above procedure to allow a skipped memory channel to be
scanned again. The flashing lock icon will cease flashing.
DELETING MEMORY CHANNELS
 Recall a Memory Channel as described above.
 Push and hold the CLR button for one to two (1‐2) seconds
 MEM‐XX will flash twice.
 The selected Memory Channel is now empty.
 Other Memory Channels are not affected when an individual Memory
Channel is deleted.
 You are now in Memory Channel mode, on the next Memory Channel
that has a location stored in it.
Push the CLR button to exit Memory Channel mode at any time.
MEMORY BANK SCANNING
By default, any Memory Channels stored are scanned sequentially
whenever Memory Channels are scanned. However, you may prefer to
break up your memory channels into banks so that only 10 of them are
scanned at any one time. This is useful for programming small groups of
frequencies that you scan through at a particular location, such as at an
air show or at particular airports.
To turn Memory Bank Scanning on and off, see the Advanced Settings
section of this manual.
When Memory Bank Scanning is enabled, only Memory Channel Scanning
behavior is affected. All 100 Memory Channels can still be stored and
accessed normally. However, when a scan is initiated, only the Memory
Channels that start with the same number are scanned. For example, if
you start a scan from Memory Channel 34, only Memory Channels 30‐39
are scanned. Similarly, if you start a scan from Memory Channel 03, only
Memory Channels 00‐09 are scanned.