Dynon Avionics EMS-D10 Installation Guide - Manual (Page 58)

EMS Configuration
General Purpose Inputs
In each of the 3 EMS GP INPUT submenus, you must
select the function corresponding to the sensor that is
installed for the respective GP connection. Ensure that you
have configured your info items on the main and aux pages
to display the desired GP inputs. Note that each GP menu
will have help text, reading “DISPLAYED: INFO #” for
each info item position where the given GP parameter is
displayed. If the given info item is not configured to display
anywhere, no text will be shown. Configure the info item
(bar, text, or flaps/trim) for each GP input to display in the
desired location(s)s, as described in the EMS-D10 Pilot’s User Guide > Global Configuration
Settings > Info Item Configuration section.
The General Purpose Inputs listed below the HS34 INPUTS section, (HS34 GP INPUT 1,
2, 3) can only be used with an HS34 installed and configured
We recommend that you set the FUNCT for all unused GP inputs to UNUSED.
ROTAX CHT
Select GP INPUT 1 and press SEL to change the FUNCT parameter to ROTAX CHT L. Back
out and select GP INPUT 2 and press SEL to change the FUNCT parameter to ROTAX CHT R.
Refer to the Cylinder Head Temperature (CHT) setup section on page 5-11 for information about
changing the various CHT-related parameters.
RESISTIVE FUEL LEVEL
Under the desired GP input number, set FUNCT to FUEL LVL 3 or FUEL LVL 4 (if FUEL
LVL 3 has already been chosen on a different GP input). All fuel level inputs use the same alarm
settings. Configure these as described in the Alarm and Color Threshold Configuration on page
5-2.
CARBURETOR TEMPERATURE
Under the desired GP input number, set FUNCT to
CARB TEMP. Select the analog bar thresholds as
described in the Alarm and Color Threshold
Configuration on page 5-2. Set the SENSOR
TYPE to the correct number using the sensor type
table.
Sensor
Type
Carburetor Temp Sensor
1
Dynon P/N 100413-000
(with black wires)
2 GRT CARB-01
Dynon P/N 100468-000
3
(with white/black wires)
5-16 EMS-D10 Installation Guide