Dynon Avionics EMS-D10 Installation Guide - Manual (Page 55)

EMS Configuration
Fuel Level
If one or more fuel level transducers have been installed,
set the DISPLAY parameter to ON; if no fuel level
sensors are installed, set it to OFF. Select the alarm
mode and the analog bar thresholds as described in
Alarm and Color Threshold Configuration on page 5-2.
You may select the on-screen names for the Tank 1 and
Tank 2 inputs. You may choose from LEFT, MAIN, and
TNK1 for Tank 1. You may choose from RIGHT, AUX,
and TNK2 for Tank 2. Change the SENSOR TYPE to
the correct number using the sensor type table.
Sensor
Type
Fuel Level Sensor
1
Resistive float-type
sender
2
Capacitive
sender(voltage output)
Fuel Pressure
If the fuel pressure transducer has been
installed, set the DISPLAY parameter to ON,
otherwise, set it to OFF. Select the alarm mode
and the analog bar thresholds as described in
Alarm and Color Threshold Configuration on
page 5-2. Change the SENSOR TYPE to the
correct number using the sensor type table.
Sensor
Type
Fuel Pressure Sensor
Dynon P/N 100411-000
(carbureted)
1
Dynon P/N 100411-001
(injected)
2
GRT LPS-02 (remove the
external pull-up resistor)
3
EMS-D10 Installation Guide 5-13