Dillon FI-90 - Manual (Page 17)

17
The cutoff connector located on the bottom of the indicator is a nine-pin
female connector. Figure 7 shows the pin assignments.
Signal Name Pin Number
+12v (on 12v units) #9
+ Relay voltage #6
Cutoff 0 #1
Cutoff 1 #2
Logic ground #5
Shield #7
Remote input #4
Figure 7
Cutoff Connection Pin Assignments
1. From gross or peak-view mode,
press MENU repeatedly until
Hour is displayed, then press
PRINT / SELECT. . . A 12-hour clock displays time in
hours and minutes, plus A for
A.M. or P for P.M: 09 40 A . A 24-
hour clock displays hours, min-
utes, and seconds: 09 40 38.
2. Set the clock by entering data in
the desired format, as shown in
the outcome to step 1 (12- or
24-hour time), using the data
entry procedure documented
under Entering Data with Arrow
Keys. Start by changing AM to
PM or vice versa, if necessary:
use UP ARROW to scroll through
numbers to this display, . .- A or . .- P
then press LEFT ARROW to
change A to P or P to A. . . . 0 P or . 0 A. Zero is now in the
edit-character position, ready for
the leftmost digit of the time data
string to be entered.
Cutoff Connections
Viewing and Setting Time
If you enter an incorrect
character, press ZERO /
CLEAR to backspace and
delete the wrong character,
then rekey.