Dillon FI-90 - Manual (Page 10)

10
For the standard AC version (See Figure 2): Plug the power cord into the
back of the indicator and connect the cord with an external AC power source.
For the AC / lead-acid battery version (See Figure 3): The power switch
controls your choice of AC power or internal lead-acid battery power. To use
external AC power, depress the bottom portion of the power switch, and plug
the power cord from an AC power source into the AC receptacle. To use the
internal lead-acid battery, depress the top portion of the power switch.
For the alkaline battery version (See Figure 4): Press the power switch to
the ON position (lower portion depressed).
For the 12-volt DC version (See Figure 5: Press the power switch to the ON
position (lower portion depressed).
Your unit is configured to display gross force or peak force. It may also be
configured to display one or more of the following functions: ID number, one or
two cutoff registers, time, and date. This manual assumes the unit is config-
ured to allow full access to all functions. The following flowchart and instruc-
tion procedure explains how to move around in and use the operations menu.
Figure 6
Operations Menu
Press MENU to à
Press SELECT to go á or â
Press and hold MENU to go ß
Press SELECT to select new choice and go á
Getting Around in the Operations Menu
The FI-90 indicator powers up
in the same mode it was in
when power was removed.