Daiwa SEABORG-1000MT - Manual (Page 9)

7
JIG/PICKUP BUTTON
Selection between pickup and jigging can be done in the mode setting display.(One of them should necessarily be chosen.)
Pickup
-You can wind only while pressing this button. This function is useful to wind up line slack and attract fish.
- Winding speed can be changed with the mode setting display. (Default setting is speed 15)
Jigging
- Jigging can be ON/OFF.
- Pressing this button starts jigging. (Display shows )
- Pressing the button again stops jigging.
Chumming timer (Power indicator, time to wind up, timer display)
- The chumming timer appears when motor rotation is stopped.The timer display cannot be set to OFF.
- While using the power lever, the power level is shown.
- While the electric winding up is in action displaying actual winding speed, the timer indicates the remaining
time to auto stop at the ship side(in minutes and seconds).
Names of the buttons and the display
9
4
Depth counter
- It shows the depth from the surface.
10
6
7
Inverse counter (winding speed display)
- This counter shows the depth from the bottom (or a certain depth).
- Once this counter is turned on, its display cannot be turned off.
- While winding up, winding speed appears in meters per minute.
(The display of winding speed can be set to OFF)
Jigging display
- This is appeared only when the jigging function is on.
- It blinks when jigging is in process.
(While the depth indicator is shown, the lamp will not light up even when it is set.)
8
Pressing the JIG/PICKUP BUTTON makes the function work. Pressing the button again stops
it.
Display Function
Mode display
- This display allows you to change setting of each function.
- The functions that are set to work are shown on the display.
(Default setting is speed 15, but the speed can actually be set between 0~Hi.)
5
Display Function Function Display
Chumming timer starts working.
The distance from the bottom is constantly
displayed.
Auto Line feeding is employed. Default
setting is off.
- If water depth is less than the auto stop depth, line is wound only in the Power Range mode for your safety.
- When the motor is used to feed line, pressing the SHIFT BUTTON will not shift out of the Power range mode.
SHIFT BUTTON , SPEED/POWER RANGE INDICATOR
- Pressing this button switches the modes between the Speed range mode and the Power range mode.
- A green lamp is lit while in the Speed range mode, a red lamp is lit while in the Power range mode.
Pressing the RESET BUTTON makes this
indicator appear. (If the RESET BUTTON
is not pressed, Auto Stop will work at 5.0m
from the broadside.)
While the
JIG/PICKUP BUTTON is being
pressed, the line can be electrically
wound up.
If the supply voltage drops, the indicator
will blink. (Pressing the MODE BUTTON
does not change the indication.)