Daiwa SEABORG-1000MT - Manual (Page 14)

12
Line data input
(With backing line 1)
This method requires use of Daiwa braided line that is color coded to show length and has a total
length greater than 100 m.
1. Run the backing line through the levelwind guide and tie it onto
the spool. The levelwind threader makes this process easier.
Make sure to tie the line onto the pin found on the spool to
avoid the line slipping.
7. Press the MODE SETTING BUTTON for 5 seconds, when the
display will show 0.0 .
P1 will be blinking.
5.
Wind the backing line.
6. Tie the backing line securely to the main line.
6
2. Move the power lever to the OFF position.
3. Connect the clip to the power source (12V DC).
4. Attach the cord connector to the reel.
See in page 2 for the connection method.
Backing line
1 Levelwind Guide
Pin
Power lever
8
8. Press the MODE BUTTON twice and change the display to
backing line input.
P2 will then be blinking.
2
Main line
Backing line
Tie
7