Daiwa SEABORG-1000MT - Manual (Page 20)

18
- If you press the shift button to change the range mode, the lamp
of the mode you are shifting to will light up.
The picture shows a case where the Speed range mode is
switching over to the Power range mode.
The SHIFT BUTTON does not work while the lamp is blinking.
- To reduce shock caused by the switchover, the power output
gradually changes until it reaches the level set by the power
lever.
- Use this mode when you value speed more than power, for
collecting your rig, etc.
- The green lamp is lit.
- The breaker will never trip during operation in the Speed range
mode. However, if an overloaded state continues, the Speed
range mode will automatically switch over to the Power range
mode to lower the speed.
In this case, pressing the SHIFT BUTTON does not switch over
the Power range mode to the Speed range mode.
- If water depth is less than the auto stop depth, line is wound in the
Power Range mode for your safety.
- When the motor is used to feed line, pressing the SHIFT BUTTON
will not shift out of the Power range mode.
Functional setting operation
(2. How to use the SHIFT BUTTON)
Pressing the SHIFT BUTTON enables you to change the electric reel winding mode between the Speed range
mode and the Power range mode.
SHIFT BUTTON
Attention
1.The motor stops temporarily at the moment of switchover
between the Speed range mode and the Power range
mode.
2.If a switchover is made between the Speed range mode and
the Power range mode under no-load conditions, the
handle will rotate.
Speed range mode
Power range mode
- Use this mode from the beginning when you value power more
than speed, for big-game fishing, midwater fishing, etc.
- The red lamp is lit.
Operation during mode change
The green lamp is lit
The red lamp is lit
The red lamp blinks