CANOGA PERKINS 9145ELB Network Interface Device Hardware - Manual (Page 34)

9145ELB NID Hardware User’s Manual Installation
Connecting the Electrical Power
20
7. Align the screw holes in the grounding lug with the mounting holes at the center of the
back of the 9145ELB.
8. Install the two screws included with the grounding lug kit. Torque the screws to 14.5 –
15.5 in-lb.
Figure 3-8 Install Grounding Lug
3.8.4 Connecting the Fiber Optic and UTP Ethernet Cables
3.8.4.1 Optical Fiber Cable Installation
NOTE: To avoid damaging the fiber end-surface or connector, use extreme care when installing
or removing cables.
Connect the Optical Fiber cables to the SFP modules as follows:
1. Plug in the optical cables with proper Tx-to-Rx or Rx -to-Tx orientation.
2. Ensure connector locks in place.
3. Label each cable with the signal direction (Tx or Rx).
3.8.4.2 UTP Cable Installation
Connect the UTP cables to the RJ45 connectors as follows:
1. Plug the UTP Cable into the RJ45 connector.
2. Be sure the locking tab is properly seated.