Beckett CG50 - Manual (Page 31)

31 CG15, CG25, CG50 Burner Manual
Propane Restrictor Description
The Beckett Propane Restrictor Conversion Kit allows for
the conversion of CG15, CG25, and CG50 burners for
use with propane gas. With the proper installation of the
restrictor and attached O-ring, adjustments and settings
for propane use will be the same as the adjustments
and settings for natural gas use as detailed in the burner
manual.
Installation
Note that Steps 1 and 2 on the reverse side refer to fully
assembled burners. Skip to Step 3 when converting a
burner without the air tube assembly installed. Refer to
Figures 16 and 17 when performing the following steps.
Figure 16 – Propane Conversion Major Components
Figure 17 – Component Locations
Major Component Key for Figure 16 & 17
A Air Tube E External Gas Manifold
B Jacking Screw F Propane Restrictor
C Internal Gas Tube G Restrictor O-ring
D Burner Housing H Gas Tube O-ring
Section: Maintenance and Service
This conversion kit shall
be installed by a qualifi ed
service agency in accordance with the
manufacturer’s instructions and all
applicable codes and requirements of the
authority having jurisdiction. (In Canada,
in accordance with the requirements of the
CAN/CGA-B149 Installation Code.) If the information
in these instructions is not followed exactly, a fi re,
explosion, or production of carbon monoxide may
result causing property damage, personal injury or
loss of life. The qualifi ed service agency is responsible
for the proper installation of this kit. The installation
is not proper and complete until the operation of the
converted appliance is checked, as specifi ed in the
manufacturer’s instructions supplied with the kit.
CG15 is shown in the illustrations.
CG25 and CG50 are similar. CG10 is
similar with the exception of having the gas gun assembly
mounted into the air tube instead of the housing.
B
E
H
G
F
C
B
C
A
D
E
H G
F