Sangean PR-D8 (R3) - Manual (Page 13)

12
Setting the HWS (Humane Wake System)
Buzzer Alarm
A beep will active when selecting the HWS buzzer alarm. The alarm
beep will increase in volume every 15 seconds for one minute followed
by one minute silence before repeating the cycle.
The HWS alarm will sound for an hour until turning off by pressing the
power button. Press the power button while the alarm is activated and
will cancel the alarm for 24 hours.
1.
2.
3.
4.
5.
6.
GB
The HWS buzzer alarm can be set in both ways (radio on or off).
Press and release HWS buzzer button , the symbol will show on
the display.
Press and hold button for more than 2 seconds followed by a
beep, display hour digit will flash.
Pressing tuning up/down to select required alarm hour and then by
pressing button again, the minute digit will flash.
Pressing tuning up/down button to select required alarm minute, press
the button again to complete alarm setting. Display will appear
when buzzer alarm has been set.
Press and hold the buzzer alarm button for more than 2 seconds
followed by a beep to switch the alarm to on or off.
when buzzer alarm has been set.