Manual tuning/station searching – Sangean PR-D8 (R3) User Manual
Page 10

9
Manual Tuning/Station Searching
1.
2.
3.
4.
5.
6.
Storing Stations in Preset Memories
There are 5 memory presets on each waveband.
1.
2.
3.
4.
5.
Press the power button to turn the radio on.
Select the required waveband by pressing the band button. Adjust
the antenna as described above.
A single press on either the tuning up or down button will change the
frequency in the following increments:
FM: 50 or 100 kHz
AM (MW): 9 or 10 kHz
Press and hold either the tuning up or down button until the frequency
in the display begins to change rapidly and release the button. Your
radio will search the selected waveband and will stop automatically
when it finds a station with sufficient signal.
Rotate the volume control to get the required sound level.
To turn the radio off, press the power button. Display will show OFF.
Press the power button to turn the radio on.
Tune to a required station using one of the methods previously
described.
Press and hold down the required station preset number until the
radio beeps. The preset number will appear in the display and the
station will be stored under chosen preset station.
Repeat these procedures for the remaining presets.
Stations stored in preset memories can be over written by the fol-
lowing above procedures.