Belt Drives EVB-2S - Manual (Page 5)

your kit contains the new Quiet clutch then refer to the lower diagram below. Install pressure plate, springs and
shoulder bolts.
procedure until all 6 bolts are in place, then tighten them all the way down until they bottom out. There is no
adjustment to the spring pressure, this is all pre-determined with the length of the shoulder bolt and exact
dimensions of our pressure plate. (Fig. 10)
11. Clutch screw adjustment should be approximately 1/4 turn loose from lightly seated. (Note when clutch is
hot the adjustment screw should not be seated). Tighten rod nut when adjustment is complete. (We supply a
clutch adjusting rod and nut for all models 1990-up only). (Fig. 11. 11a)
Fig.11 Install clutch adjusting rod supplied with kit 1986-up. and adjust clutch.
Fig. 11a Finished installation. Be sure to check clearance of outer cover to drive.
5
To install shoulder bolts apply red
Loctite® to a bolt and install it one turn, go on to the next bolt with same