Vernier LabPro - Manual (Page 30)

Vernier LabPro User’s Manual C-2
pH Sensor PH-BTA
Tris-Compatible Flat pH Sensor FPH-BTA
Photogate VPG-BTD
Polarimeter (Chemical)
CHEM-POL
Power Amplifier PAMP
Vernier Projectile Launcher VPL
Pyranometer PYR-BTA
Digital Radiation Monitor
DRM-BTD
Vernier Radiation Monitor VRM-BTD
Relative Humidity Sensor RH-BTA
Respiration Monitor Belt (requires GPS-BTA) RMB
Rotary Motion Sensor RMV-BTD
Salinity Sensor SAL-BTA
Soil Moisture Sensor SMS-BTA
Sound Level Meter SLM-BTA
Spirometer SPR-BTA
Direct-Connect Temperature Probe
DCT-DIN
Extra Long Temperature Probe TPL-BTA
Stainless Steel Temperature Probe TMP-BTA
Surface Temperature Sensor STS-BTA
Wide-Range Temperature Probe WRT-BTA
Thermocouple TCA-BTA
TI Light Probe
TILT-BTA
Time of Flight Pad TOF-VPL
Turbidity Sensor TRB-BTA
UVA and UVB Sensors UVA/UVB-BTA
30-Volt Voltage Probe 30V-BTA
Differential Voltage Probe DVP-BTA
Voltage Probe VP-BTA
Wireless Dynamics Sensor System WDSS
Adapters for Older Sensors
Vernier sensors purchased prior to the introduction of LabPro can probably be adapted to work with
LabPro. Most of our analog sensors were previously manufactured with a round, 5-pin “DIN” plug.
If you have an older DIN sensor, you will need a DIN-to-BTA adapter (order code DIN-BTA). This
chart shows some of the adapters or replacement cables that can be used with other sensors. You
may have sensors that do not appear in this table. Contact us to discuss your situation.
Sensors Purchased Prior to 2000 Adapter or Cable Order Code
Vernier Analog 5-pin DIN sensors DIN to BTA adapter DIN-BTA
Vernier Photogate (with removable cable) Digital Photogate Cable PG-BTD
Radiation Monitors Radiation Cable RAD-BTD
Motion Detector (with removable cable) Motion Detector Cable MDC-BTD
Motion Detector (without removable cable) CBL-RJ11 Adapter CBL-RJ11
Rotary Motion Sensor Rotary Motion Adapter ROT-BTD