Vernier LabPro - Manual (Page 23)

Vernier LabPro User’s Manual 19
Sensor Warm-Up Times
Some sensors require a certain warm-up period before an accurate measurement can be taken. LabPro
handles this automatically in remote modes by warming up each sensor for the appropriate amount of
time. The Turbidity Sensor, for example, requires a 2-second warm-up period.
The table below lists all sensors with warm-up times of 2 seconds or longer. If a sensor is not on this list,
its warm-up time is negligible.
Sensor Warm-Up Time
(s)
Ammonium Ion-Selective Electrode 2
Calcium Ion-Selective Electrode 2
Chloride Ion-Selective Electrode 2
CO
2
Sensor 90
Colorimeter 300
Conductivity Probe
2
Dissolved Oxygen Probe 600
Dual-Range Force Sensor 2
Electrode Amplifier 30
Flow Rate Sensor 2
Force Plate 2
Nitrate Ion-Selective Electrode 2
Oxygen Gas Sensor 2
pH Sensor 30
Turbidity Sensor 2
UVA Sensor 2
UVB Sensor 2
The following sensors cannot be set up to collect remote data:
Digital Control Unit
Drop Counter
Heat Pulser
Photogate
Radiation Monitor
Student Radiation Monitor
Rotary Motion Sensor
Digital Radiation Monitor