Rane AC 23B (2003 version) - Manual (Page 10)

Manual-
REAR PANEL: MONO 4-WAY AND MONO 5-WAY INSTALLATION
MONO 5W (CHANGE INTERNAL SWITCH FOR MONO 4W) HI MID OUT-5W LOW OUT HIGH OUT
OMIT-4W
OMIT MONO
MADE IN U.S.A.
RANE CORP.
LOW-3W / OMIT-2W MID-3W / LOW-2W HIGH OUT
3W 2W
CHANNEL 2
STEREO
CHANNEL 1
STEREO
MONO
MONO 4W / 5W IN OMIT MONO SUB OUT MID OUT
LOW-3W / OMIT-2W MID-3W / LOW-2W
3W 2W
STEREO
STEREO 3W / 2W HIGH OUT
PIN 3=NEGATIVE
PIN 1=CHASSIS GND
PIN 2=POSITIVE
AC 23B
CLASS 2 EQUIPMENT
CHANNEL 2 IN CHANNEL 1 IN
MONO: SET SWITCHES AS SHOWN 260mA
POWER
7
Mono 4- and 5-Way labels in this row.
6
9 10 8
High Amp
High-Mid Amp
Input
5
4
Mid Amp
Low Amp 3
Sub Amp 2
1
* *
* *
**
THIS OUTPUT IS NOT USED FOR 4‑WAY MONO OPERATION.
4‑WAY USERS SEE INTERNAL SWITCH INSTRUCTIONS ON PREVIOUS PAGE.
Observe the labels below the Inputs and Outputs for Mono operation.
1 MONO INPUT: Connect the output from your mixer or other signal source only to the CHANNEL 1 INPUT for Mono opera-
tion; do not use the Channel 2 Input. Pin 2 is “hot” per AES standards.
2 SUBWOOFER OUTPUT: Connect the SUB OUT to the input of the subwoofer (or bass bin) amplifier.
3 LOW OUTPUT: Connect the LOW OUT to the input of the low frequency (mid-bass) amp.
4 MID OUTPUT: Connect the MID OUT to the input of the mid frequency amplifier.
5 HlGH-MID OUTPUT (FOR MONO 5-WAY ONLY): Use this Output only for Mono 5-Way applications. Omit this output
when using the AC 23B as a Mono 4-Way Crossover. Mono 4-Way Switch Instructions are on the previous page. In 4-Way the AC 23B
internally bypasses the High-Mid section and defeats all front panel High-Mid Controls. For Mono 5-Way connect the HIGH-MID
OUT to the input of the high-mid frequency amplifier.
6 HIGH OUTPUT: Connect the HIGH OUT to the input of the high frequency (tweeter) amp.
7 2-WAY / 3-WAY switches: Converts each channels outputs from 3-Way to 2-Way. For Mono 4-or 5-Way, slide these switches to the
3-WAY position.
8 MONO-STEREO switch: Push this to the MONO in position.
9 POWER input connector: Use only a model RS 1 or other power supply approved by Rane. This unit is supplied with a remote
power supply suitable for connection to this input jack.
0 Chassis ground point: A #6-32 screw is used for chassis grounding purposes. Always connect the crossover chassis to the ampli-
fier chassis. See ‘Chassis Grounding’ on page Manual-1 for details.