Wilbur Curtis RSTB with Dual Dilution & Sweetener Option - Manual (Page 7)

7
DAILY
1. Wipe any spills, dust or debris from the exterior surfaces with a damp cloth. The
outside surfaces of the brewer should be cleaned with stainless steel polish only, to
prevent scratches.
2. Clean the sprayhead and domed area around the sprayhead with a mild detergent
and warm water solution. Scrub well to remove residue. Rinse with and clear water.
Dry with clean cloth.
3. Remove the plastic brewcone and wash with a detergent solution or put through a
dishwasher.
4. Wash the tea container.
A. Clean container and top cover with a detergent solution.
B. Remove the faucet assembly. Unscrew the handle assembly from the faucet
and remove. Clean the faucet shank with a gauge glass brush (circular bristle)
by pushing the brush through the shank.
C. Unscrew the bonnet assembly from the faucet. Brush clean the faucet body inlet
and outlet. Clean the faucet cap and silicone seat cup. Dry and assemble parts.
IMPORTANT: Clean out
the screen, within the
brewcone, to maintain
the flow of brewed
tea. Neglecting this screen will
eventually cause the brewcone to
overflow, spilling hot liquid over the
unit.
CAUTION: DO NOT
use undiluted bleach or
chlorine.
TEA BREWER
CLEANING
SWEET TEA
MIXING SYSTEM
CLEANING &
SANITIZING
CAUTION: Never remove
faucet when container is
full. Drain container first.
WEEKLY CLEANING & SANITIZING
The brewer is programmed for the sweetener to pour into the tea at the end of the
brewcycle. Setting the brewer to Tea Fast Brew can speed up the cleaning procedure
(see page 3 and 4 for programming instructions to turn on Tea Fast Brew).
Use a concentrated cleaning solution to simplify the cleaning procedure. This
procedure requires a one gallon bucket of a cleaning solution of hot water (minimum
160ºF) and a granulated concentrated cleaner (a cleaner like Coffee Dispenser
Cleaner Corporation JavaClean3), diluted at 1.5 oz per gallon and a one gallon bucket
of clean hot water (minimum 165ºF).
1. Make sure brewer is on and water supply is hooked up.
2. Remove the quick disconnect from the tea sweetener bag-in-box product.
3. Pull the cap off of the QCD and place this end of the line into the container
containing the cleaning solution (see illustration below).