Wilbur Curtis RSTB with Dual Dilution & Sweetener Option - Manual (Page 4)

4
All programming selections are performed with the three center buttons.
The symbols below the buttons are:
Scroll LEFT
 SELECTION or ENTER to save new parameter
Scroll RIGHT
Exit Press  to select, exits program mode and returns unit to operation.
Programming
ENTER PROGRAMMING: Turn off at the ON/OFF button (yellow). Press and hold BREW button (green) and then press and release ON/OFF button (yellow).
Continue holding BREW button. Display will read , wait until is displayed Enter the 4-digit access code, the digits 1-4
correspond to the buttons (see illustration below).
The default code set at the factory is 1-2-3-4. Then will be displayed.
Program Menus
Tea By Volume
Tea Recipes
Tea By Time
Program Menus screen. Press > button, to show the next menu item.
Tea Recipes (Factory set to Standard Purple)
Press  to Select. Press < or > to scroll through recipes: Standard Gray, Standard Purple, Tropical Gray, Tropical Purple,
76/308 Gray or 76/308 Purple. Press  to set.
Tea by Volume: Press  to select, Display will now show Push START To Begin... Press the BREW button. At this time,
hot water will start to flow. When desired volume is reached press BREW button again to stop the flow. Now the tea
volume has been set.
Tea by Time (Factory set to Standard Purple 5:52)
Press  to Select. By pressing < or > buttons, you can view selections available: Standard Gray, Standard Purple, Tropi-
cal Gray, tropical Purple, 76/308 Gray or 76/308 Purple. Press  to set.
Tea Dilution Delay (Factory set to Standard Purple 30 sec)
Press  to Select. Press < or > buttons, to view selections available: Standard Gray, Standard Purple, Tropical Gray,
tropical Purple, 76/308 Gray or 76/308 Purple. Press  to set.
Tea Dilution Volume: Press  to Select, Display will now show Push START To Begin... Press the BREW button and
water will flow. When desired volume is reached press BREW button again to stop the flow. Now the tea dilution volume
has been set.
Dilution Time (Factory set to Standard Purple 4:05)
Press  to Select. Press < or > buttons, to view selections available: Standard Gray, Standard Purple, Tropical Gray,
tropical Purple, 76/308 Gray or 76/308 Purple. Press  to set.
Tea Dilution Stir (Factory set to Standard Purple ON).
Press  to Select. Press < or > buttons, to view selections available: Standard Gray, Standard Purple, Tropical Gray,
tropical Purple, 76/308 Gray or 76/308 Purple. Press  to set. Dilution Stir applies only to the Dilution cycle, by pulsing
the dilution time 45 seconds on, 5 seconds off.
Tea Pulse Brew (Factory set to OFF).
Press  to Select. Press < or > to toggle between OFF, ON or D (manual programming). Pulsing will begin after 30
seconds of water flow. In D setting, the pulse count range is 1 to 20 pulses. Water on time is 5 to 150 seconds (5 sec
increments).
Tea Fast Brew (Factory set to OFF).
Press  to Select. Press < or > to toggle between OFF and ON. Fast Brew is a brew time setting. The brew time range is
30 seconds to 10 minutes, in 30 second increments.
Tea Dilut Volume
Tea Dilut Delay
Tea Dilut Time
Tea Dilut Stir
Tea Pulse Brew
Continued on Page 4
Tea Fast Brew