Wilbur Curtis RSTB with Dual Dilution & Sweetener Option - Manual

1
Symbols:
WARNINGS – To help avoid personal injury
Important Notes/Cautions – from the factory
Sanitation Requirements
Models Included
• RSTB with Dual Dilution
& Sweetener Option
Important Safeguards/Symbols
This appliance is designed for commercial use. Any servicing other than cleaning and routine main-
tenance should be performed by an authorized Wilbur Curtis Company service technician.
• DO NOT immerse the unit in water or any other liquid
• To reduce the risk of fire or electric shock, DO NOT open service panels. There are no user
serviceable parts inside.
• Keep hands and other items away from hot areas of the unit during operation.
• Never clean with scouring powders or harsh chemicals.
Your Curtis G3 Brewer is Factory Pre-Set and Ready to Go, Right Out of the Box.
Following are the Factory Settings for your RSTB Tea Brewing System:
• Brew Temperature = 204°F
• Brew Volume = Set to dispensing vessel requirements (2.2 liters)
Generally there will never be a reason to change your G3 programming. However, should you
need to make slight adjustments to meet your brewing needs, programming instructions are pro-
vided later in this manual.
System Requirements:
• Water Source 20 – 90 PSI (Minimum Flow Rate of 1 GPM)
• Electrical: See attached schematic for standard model or visit www.wilburcurtis.com for
your model.
Equipment to be installed to comply with applicable federal, state, or local plumbing/electrical codes
having jurisdiction.
NSF International requires the following water connection:
1. A quick disconnect or additional coiled tubing (at least 2x the depth of the unit) so that the machine
can be moved for cleaning underneath.
2. This equipment is to be installed with adequate backflow protection to comply with applicable
federal, state and local codes..
3. Water pipe connections and fixtures directly connected to a potable water supply shall be sized,
installed and maintained in accordance with federal, state, and local codes.
1. Plug in power cord.
2. Plumb water line. A 1/4” Flare has been supplied for water line connection. Use tubing sized suf-
ficiently to provide a minimum of 1.0 GPM.
3. Connect the Bag-in-Box sweetener. Take the clear line with the QCD bag connector and hookup
to the matching connector on the BIB sweetener (see Sweetener Connection, page 8).
SETUP STEPS
The unit should be level (left to right and front to back), located on a secure surface. Connect a
water line from the water filter to the brewer.
NOTE: Some type of water filtration device must be used to maintain a trouble-free operation.
(In areas with extremely hard water, we suggest that a sedimentary and taste & odor filter be
installed.) This will prolong the life of your brewing system and enhance tea quality.
IMPORTANT: After
setup, run a FULL
brewcycle. Place a tea
container to catch both hot water
from the brewcone and dilution
water from spout on the front
cover.
ISO 9001:2008 REGISTERED
WILBUR CURTIS CO.
Montebello, CA 90640
For the latest information go to
www.wilburcurtis.com
Tel: 800/421-6150
CAUTION: DO NOT
connect the unit to hot
water. The inlet valve is
not rated for hot water.
CAUTION: Follow this
setup procedure before
attempting to use this
unit. Failure to follow these instruc-
tions can result in injury and/or void
of warranty.
CAUTION: Equipment
must be installed to
comply with applicable
federal, state, and local plumbing/
electrical codes having jurisdiction.
W
ilbur
C
urtis
C
ompany
, i
nC
.
Service Manual – RSTB Dual Dilution/Sweet Tea
FOR THE LATEST SPECIFICATIONS AND INFORMATION GO TO WWW.WILBURCURTIS.COM