Wilbur Curtis RSTB with Dual Dilution & Sweetener Option - Manual (Page 3)

3
Your Curtis ADS System is Factory Pre‑Set for Optimum Performance.
After connection to water and power; the rear toggle switch must be on. You will hear a beep sound, indicating power is available to the controller.
The control displays . Press ON/OFF button and the screen will display . After three seconds, is displayed.
Water will fill the tank (approximately 2-3 minutes depending on water flow rate). When the proper level is reached will appear on the screen.
It takes approximately 20 minutes to reach setpoint temperature of 204°F.
Control will display when temperature reaches the setpoint (204°F). Unit is now ready to brew.
CURTIS
Ready to Brew
CURTIS
CURTIS
CURTIS
Filling
CURTIS
Heating
1. Brewer should be ON (Confirm at rear toggle switch, then press ON/OFF button) and Ready-to-Brew displayed.
2. Make sure tea containers are in place, sitting on the brew deck.
3. Place a paper filter
in the brew basket.
Pour leaf tea into
the filter.
Place the filter into
the brew cone.
4. Slide the brew
cone into rails
on the tea
brewer.
6. On the UCM,
press the brew
button that cor-
responds to the
brew selected
in step 5.
The brew cycle
will start.
5. Select the tea
container you wish
to brew into.
Rotate the brew
cone to direct the
liquid flow into
the selected tea
container.
Tea Brewing Instructions
CAUTION HOT LIQUID, Scalding may occur. Allow the brew cone to completely drain before removing.