Wilbur Curtis GEM3IF - Manual (Page 6)

6
Error Message
An error message will appear on the
screen in the event of a malfunction
under the following conditions:
1. Water level overflow.
2. Break in temperature control
circuit.
3. Excess temperature in heating
tank
4. Scale build-up on liquid level
probe, inside the heating tank.*
To turn off an error message, press
the ¤ button for five seconds.
* The Scale error features will begin
appearing in later versions of GEM
Intellifresh brewers.
Warmers
The warmer, under the brewcone will turn on automatically whenever a coffee brew cycle is started. The warmers may be switched on and off
using the WARMER buttons on the control panel.
Model Select
Model Select (Factory set to Gemini-Twin IF)
Press ¤ to select, < or > to select model. The selections are: ThermoPro-Twin, ThermoPro-Single, Gemini-Twin, Gemini-
Single, Milano-Twin, Milano-Single, Gemini-Twin IF, and Gemini-Single IF. Press ¤ to set. When the Model Select feature is
changed, all settings are reset to the defaults of the newly selected model. Also, the next feature Batch Select appears.
Batch Select (Factory set to One Batch)
Press ¤ to select, < or > to select One Batch, Two Batch or Three Batch. Press ¤ to set. Display exits programming mode
and returns to normal operation.
Program Menus GEMIF Brewer
Language (Factory set to English)
Press ¤ to Select. Press < or > to move to English or French. This feature is programmable for changing and adding
languages.
Language
By-Pass (Factory settings: LARGE 35%. MEDIUM 10%. SMALL Off.)
The By-Pass option helps with controlling extraction with larger brews. Contact time that is too long will extract undesirable
bitter, harsh flavor compounds. By-passing some of the brew water around the coffee bed will balance the extraction.
Press ¤ to display current setting. Press < or > to change settings; OFF, 5% to 50%, in 5% increments. Press ¤ to set.
By-Pass