Wilbur Curtis GEM3IF - Manual (Page 2)

2
GEMINI IF BREWER
SATELLITE
UCM CONTROL
IF CONNECTOR
INTELLIFRESH FUNCTION & FEATURES
WARNING: TO AVOID SCALDING, Do not remove brewcone while brew light is flashing.
1. Brewer should be ON. Confirm this at rear toggle switch, then press the ON/OFF button on the UCM (Universal Control Module). Ready-to-
Brew should be on the display. If the brewer is connected to an InterLock grinder, the grinder should be on. When Interlock connection is
made, grind coffee at this time.
2. Position an empty Satellite onto the brew deck.
NOTE: Only utilize Intellifresh Satellites on Intellifresh Brewers.
6. Press appropriate
brew button.
Brewing will begin
immediately.
5. Transfer filled brew-
cone to brewer.
3. Place a clean filter
into the brewcone.
4. Fill brewcone with
appropriate amount
of ground coffee.
INTELLIFRESH BREWING INSTRUCTIONS
The IntelliFresh system will alert you when the coffee has exceeded the desired hold-
ing time. The Intellifresh system is activated by a connector on the Satellite connecting
to the corresponding connector on the center panel. IntelliFresh is adjustable through
the UCM controller on the brewer.
Quality Timer (Factory Set to 2 hours)
Press ¤ to select, press < or > to choose the desired setting. Range 20 min. to 240
min. The timer is intended to notify the user when the coffee loses its freshness. The
indicator light (LED) on the satellite will remain solid red until the Quality Timer expires
(Factory Set to 2 hours). At expiration the LED will flash and remain flashing at the
factory setting for an additional 8 hours. The additional 8 hours is controlled by the
Warmer Auto-Off setting (see below Warmer Auto Off).
• Setting Range: 20 – 240 minutes. The default time is 2 hours.
• Time Expiration Indicator: LED flashes after expiration of Quality Timer Setting
for up to a total of 12 hours. The default time is 8 hours after expiration of the
Quality Timer.
Warmer Auto-Off (Factory set to 10 Hrs.)
Press ¤ to select < or > to adjust from 1-12
hours. This feature has higher priority than the
Quality Timer. It shuts off the warmers after a
pre-determined time (factory set at 10 hours)
starting when the Brew Button is pushed. The
Quality Timer does not affect this function.