Wilbur Curtis GEM3IF - Manual (Page 3)

3
Display Timers
< - - Select - - >
The G3/Gold Cup Series Brewing System is Factory Pre-Set for Optimum Performance.
After connection to water and power; the rear toggle switch must be on. You will hear a beep sound, indicating power is available to the controller.
The control displays . Press ON/OFF button and the screen will display . After three seconds, is displayed.
Water will fill the tank (approximately 2-3 minutes depending on water flow rate). When the proper level is reached will appear on the
screen. It takes approximately 20 minutes to reach setpoint temperature of 200°F.
Control will display when temperature reaches the setpoint (200°F). Unit is now ready to brew.
WILBUR CURTIS
CURTIS CURTIS
FILLING
CURTIS
HEATING
CURTIS
READY
PROGRAM
MENUS
All programming selections are performed with the three center
buttons.
The symbols below the buttons are:
Scroll LEFT
¤ SELECTION or ENTER to save new parameter
Scroll RIGHT
IMPORTANT NOTE:
GEM INTELLIFRESH