Wilbur Curtis TLP61 - Manual (Page 7)

Brew Volume - Factory Pre-set Full Brew to 2.2 Liters
The Half Brew button is always half of the brewtime of the setting of the Full Brew
button. You cannot program the Half Brew.
Change the brew volume of your ADS System by following these steps.
Before changing the brew volume, wait until unit reaches brew temperature (Ready to Brew light
comes on), insert the brewcone into place on the brewer, then place a measuring container centered
beneath the brewcone.
Brew Cycle Counter
This function allows you to see exactly how many brew cycles occurred on the system.
This feature is ideal for preventive maintenance programs (i.e., changing water filters,
cleaning the sprayhead, etc.) and determining profitability. To view the number of brew
cycles on the unit, follow these steps:
TO ACCESS BREW CYCLE COUNTER
ENTER THE PROGRAMMING MODE #2:
will now start a pattern of LONG and SHORT blinks.
This pattern identifies the number of brew cycles. SHORT blinks indicate the
brew number from one [1] to nine [9]. LONG blinks separate the 1’s, 10’s,
1,000’s and 10,000’s.
BREW COUNT EXAMPLE
READY TO BREW
For ALL functions you must first enter the programming mode.
Turn OFF the power from the Control Panel by pressing .
Press and HOLD and press and RELEASE .
MODE #1
Continue HOLDING until starts blinking; RELEASE.
ENTER THE PROGRAM MODE
CHANGE BREW VOLUME - Factory Preset to Brewer Requirements
ENTER THE PROGRAMMING MODE #1: (CAUTION: Be sure to have brewcone
and vessel in position).
Press and HOLD until hot water starts running; then RELEASE.
When desired volume is reached, press again to stop flow.
To set and exit, press .
For ALL functions you must first enter the programming mode.
Turn OFF the power from the Control Panel by pressing .
Press and HOLD and press and RELEASE .
MODE #2
Continue HOLDING until STOPS blinking; RELEASE.
ENTER THE PROGRAM MODE
7
I/O
O N / O F F O N / O F F O N / O F F O N / O F F O N / O F F
I/O
O N / O F F O N / O F F O N / O F F O N / O F F O N / O F F
I/O
O N / O F F O N / O F F O N / O F F O N / O F F O N / O F F
READY TO BREW
I/O
O N / O F F O N / O F F O N / O F F O N / O F F O N / O F F
I/O
O N / O F F O N / O F F O N / O F F O N / O F F O N / O F F
READY TO BREW
1’s
10’s
100’s
1,000’s
10,000’s
1st
2nd
3rd
4th
5th
Sets Pattern Factor
4
20
300
1,000
0
01,324
Total
Total Brews
(When programming the brewer for volume, it is important to realize that after you program the unit, it
must reach full brew temperature before it will allow you to brew.)