Wilbur Curtis TLP61 - Manual (Page 5)

1. Brewer should be ON (Confirm rear toggle switch is on, then press ON/
OFF button).
2. Place an empty airpot in position, under the sprayhead.
3. Place a filter and ground coffee in the brewcone. Slide the brewcone into
position on brew rails.
4. Wait until the READY-TO-BREW light comes on and then press the desired
BREW button. The indicator light above the selected brew will begin flashing
when the brewcycle starts.
IMPORTANT: The brewcycle is adjusted at the factory to fill a standard 2.5 liter airpot with
2.2 liters of brewed coffee.
The duration of the brewcycle is set between 2 minutes, 40 seconds and 3 minutes.
BREWING
INSTRUCTIONS
5
W W W W WARNING: ARNING: ARNING: ARNING: ARNING: To avoid
scalding, do NOT
remove brew cone
while brew indicator
light is flashing.