Petsafe VT-800 Remote Vibration Trainer - Manual (Page 11)

www.petsafe.net 11
DE
FR
ES
NL
IT
EN
STEP 2
Prepare the Receiver Collar
Charge the Receiver Collar
1. Lift the rubber dust cover protecting the
Receiver Collar Charging Jack.
2. Connect one of the charger connectors to
the Receiver Collar Charging Jack (2A).
3. Plug the charger into a standard wall out-
let. The Red LED will light up. When fully
charged, the LED will change to Green.
4. When charging is complete, be sure to
replace the rubber dust cover.
To Turn the Receiver Collar On
1. Press and hold the On/Off Button (2B)
until the Green LED light comes on. (This
takes approximately one second.)
2. Release the On/Off Button.
In normal mode, the Green LED will flash once every 5 seconds,
indicating the Receiver Collar is on and ready to receive a radio
signal from the Handheld Transmitter.
To Turn the Receiver Collar Off
1. Press and hold the On/Off Button until the Red LED light shuts off.
(This takes approximately 3 seconds.)
2. Release the On/Off Button.
To extend the life between charging cycles, turn the Receiver Collar
off when it is not in use. Approximate battery life between charges is
15-20 hours, depending on frequency of use.
2A
On/Off Button
2B