B&C Technologies IP Series Commercial Ironer - Manual (Page 10)

10. Do not install the machine in an area
where it could be exposed to water or
weather.
11. Do not alter or tamper with the control
system.
12. To reduce the risk of fire, do not
process plastics or articles containing foam
rubber or similarly textured rubber-like
materials.
13. Keep the area near the exhaust ducting
clean and free of lint, dust, dirt or debris.
14. Keep the interior and exterior of the
machine clean of lint, dirt, dust and debris.
The interior of the machine, along with the
exhaust ductwork should be periodically
inspected and cleaned to avoid potential
fires (lint is highly flammable).
15. Improper installation, operation and
maintenance of this machine can cause
exposure to substances in the fuel or from
combustion that can cause serious illness or
death.
16. Always disconnect the electrical service
from the machine and allow it to cool
before performing service.
17. This machine must be installed
according to the installation instructions. All
electrical connections, and gas or steam
connections must comply with state and
local codes and must be made by a licensed
installer where required.
Important Instructions
Safety Information
10