Cabletron Systems 2000 - Manual (Page 28)

The SmartSwitch 2000 Chassis View
2-6 Viewing Chassis Information
¥ Device Find Source Address enables you to determine through which
interface a speciÞed MAC address is communicating by searching the 802.1d
bridge Filtering database. Ethernet MicroLAN switches will also search the
repeater Source Address Table (SAT). If the speciÞed MAC address is located,
a list of interface(s) through which the given address is communicating will be
displayed.
¥ Edit Device Time and Edit Device Date allow you to set the SmartSwitch
2000Õs internal clock. See Setting the Device Date and Time , on page 2-75 .
¥ System Group allows you to manage the SmartSwitch 2000 via SNMP MIB II.
Refer to the Generic SNMP UserÕs Guide for further information.
¥ I/F Summary lets you view statistics (displayed both graphically and
numerically) for the trafÞc processed by each network interface on your
SmartSwitch 2000. See
Viewing I/F Summary Information , on page 2-20 .
¥ VLAN menu option will appear in the Device menu if your device is
conÞgured to operate in 802.1Q mode. The windows launched via the VLAN
option allow you to conÞgure and operate port-based VLANs on the device.
See
802.1Q VLANs , on page 2-60 , for details.
¥ Port Redirector allows you to redirect trafÞc from one or more interfaces to
another interface on your SmartSwitch 2000; see Redirecting TrafÞc on the
SmartSwitch 2000 , on page 2-48 .
¥ System Resources displays current physical and logical system resources and
utilizations on your SmartSwitch 2000; see The System Resources Window ,
on page 2-58 .
¥ Broadcast Suppression allows you to monitor broadcast trafÞc statistics on
each interface and set thresholds to limit broadcast trafÞc over your
SmartSwitch 2000; see
Broadcast Suppression , on page 2-72 .
¥ Priority ConÞguration allows you to establish priority packet forwarding for
the SmartSwitch 2000. For more information, see Priority ConÞguration , on
page 2-50 .
¥ Com Port ConÞguration allows you to administratively Enable or Disable and
set the function of the COM Port on your SmartSwitch 2000; see ConÞguring
the COM Port , on page 2-43 .
NOTE
The Priority ConÞguration menu option will only appear in the Device menu for
devices that respond to any of SPECTRUM Element ManagerÕs queries to the following
OIDs: ctPriorityExtPortStatus, ctPriorityExtMaxNumMACEntries, or
ctPriorityExtNumPktTypeEntries
. If your deviceÕs Þrmware does not respond to these
queries, contact the Cabletron Systems Global Call Center for Þrmware upgrade
information.